case modding
Part 2: Reading Fan / Water Pump RPM
In part one I covered how to connect two temperature sensors and the LCD to our Aruino. In this installment I am going to show you how to read the RPM of the water pump. The Arduino Controlled PC Watercooling Information Display will display the water pumps RPM on one screen so I had to figure out how to read the RPM from the data output by a Hall effect sensor...more after the jump...
bitsnpeices
cgantt — Thu, 01/21/2010 - 23:32
All of the bits and peices removed from the Thermaltake Armor+
blood
cgantt — Thu, 01/21/2010 - 23:32
The wound from the cut I recieved while tearing down the Armor+
skin
cgantt — Thu, 01/21/2010 - 23:32
Yes that is my skin and that is what removed it from my person.
brokenarmor
cgantt — Tue, 01/12/2010 - 10:10
Part of the damage done to the Armor+ case during shipping. 100% UPS fault.
PS2_LCD
cgantt — Tue, 01/12/2010 - 10:10
The PS2 LCD screen I am recycling to put in the from of the COD MW2 Case.
PS2_LCD_back
cgantt — Tue, 01/12/2010 - 10:10
Back of the actual LCD screen module from the PS2 screen kit.
PS2_LCD_diagonal
cgantt — Tue, 01/12/2010 - 10:10
Diagonal measurement of the screen on the PSU LCD screen.
